Prusa3D Forum

Notifications

Clear all

Philippe Collignon

Skupina: Registrovaný

Přidal se: 2015/09/29

Active Member

	Hello, Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive)	před 10 years
	Hello, Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive)	před 10 years
	Hello, I have the same issue (see two post below) .. Nozzle ... In forum Prusa i3 kit (Archive)	před 10 years
	My sd card reader is not working all the time neither .. I ... In forum Prusa i3 kit (Archive)	před 10 years
	Extruder nozzle stoppered / clogged In forum Prusa i3 kit (Archive)	před 10 years
	I had the same issue and ended by fixing the bed to the carr... In forum Prusa i3 kit (Archive)	před 10 years
	Small rings 5 mm radius 2 mm thikness In forum Awesome prints (Hall Of Fame)	před 10 years
	First print ABS and PLA In forum Awesome prints (Hall Of Fame)	před 10 years
	Default temp 50*C .. it tried hotter (60°C) but it was not b... In forum Prusa i3 kit (Archive)	před 10 years
	Howto ABS & PLA stick to heat bed In forum Prusa i3 kit (Archive)	před 10 years
	Congratulations and thanks ! In forum Prusa i3 kit (Archive)	před 10 years
	Fixing the Heat Bed In forum Prusa i3 kit (Archive)	před 10 years
	That was the problem .. using Slice3r and setting 1.75 filam... In forum Prusa i3 kit (Archive)	před 10 years
	Ok I got it, the bar must be pushed quite deep inside the pl... In forum Prusa i3 kit (Archive)	před 10 years
	Stuck at step 16 Axis Z .. In forum Prusa i3 kit (Archive)	před 10 years

Fórum Statistiky

595 Fóra

70 K Témata

489.9 K Příspěvky

12 Online

80.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed