Prusa3D Forum

Notifications

Clear all

Philip Hoeffer

Groupe: Enregistré

A(ont) rejoint: 2017/10/27

Active Member

	Filament Sensor Just burned up! Dans le forum Others (Archive)	il y a 7 years
	Lucky you. I ordered 3 days earlier than you & just got ... Dans le forum General discussion, announcements and releases	il y a 7 years
	Thank You. It IS fixed. Only 9 of us WEEK #43 have not rece... Dans le forum General discussion, announcements and releases	il y a 7 years
	Access DENIED on Spreadsheet! Dans le forum General discussion, announcements and releases	il y a 7 years
	They are the same, BUT you will have to compile the Prusa Fi... Dans le forum Others (Archive)	il y a 7 years
	That BROWN looks to be rust. If you look at the picture, you... Dans le forum Others (Archive)	il y a 7 years
	Well done! I was wondering why this hadn't been done yet. ... Dans le forum General discussion, announcements and releases	il y a 7 years
	If it is tight, then the nut is cross threaded. the nuts sho... Dans le forum Others (Archive)	il y a 7 years
	You are actually 1 rev behind B139 is available. Dans le forum Others (Archive)	il y a 7 years
	What happened to the Spreadsheet? There are Huge holes in i... Dans le forum General discussion, announcements and releases	il y a 7 years
	That little ridge can be trimmed with a X-Acto knife if it i... Dans le forum Others (Archive)	il y a 7 years
	Just ordered a Mk3 Kit. Dans le forum General discussion, announcements and releases	il y a 7 years

Statistiques du forum

559 Forums

62.8 K Sujets

442.2 K Messages

17 En-ligne

67.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé