Phil – Activité – Prusa3D Forum

Notifications

Clear all

Phil

Groupe: Enregistré

A(ont) rejoint: 2025/12/07

Trusted Member

	I printed it with .20mm layer height instead of .15mm layer ... Dans le forum How do I print this? (Printing help)	il y a 4 months
	Thanks hyiger. What can I do to get the lettering a little c... Dans le forum How do I print this? (Printing help)	il y a 4 months
	Attached is my .3mf file for a simple screw length gauge. I ... Dans le forum How do I print this? (Printing help)	il y a 4 months
	DOH! Why didn’t I think of that? thank you Dans le forum How do I print this? (Printing help)	il y a 5 months
	BTW, I think the problem was caused by filament binding on t... Dans le forum How do I print this? (Printing help)	il y a 5 months
	Filament sensors disabled error Dans le forum How do I print this? (Printing help)	il y a 5 months
	I did exactly this but the display on C1 stated that the wro... Dans le forum How do I print this? (Printing help)	il y a 5 months
	printing multi colors manually Dans le forum How do I print this? (Printing help)	il y a 5 months
	My Core One was an assembled one. I did read somewhere that ... Dans le forum How do I print this? (Printing help)	il y a 5 months
	Is this a mod I should consider implementing Dans le forum User mods	il y a 5 months
	BTW, Thanks for everyone's help. I do appreciate it. Dans le forum How do I print this? (Printing help)	il y a 5 months
	Do they just get loose over time? Dans le forum How do I print this? (Printing help)	il y a 5 months
	I contacted Prusa CS --it was the thumb screws. They were lo... Dans le forum How do I print this? (Printing help)	il y a 5 months
	I tried again tonight but with one print part instead of mul... Dans le forum How do I print this? (Printing help)	il y a 5 months
	@foxrun3d, this is a dead link. Dans le forum How do I print this? (Printing help)	il y a 5 months
	I just printed a benchy in PLA and it came out as good as pr... Dans le forum How do I print this? (Printing help)	il y a 5 months
	What is a cold pull? Should I just print a benchy with PLA? Dans le forum How do I print this? (Printing help)	il y a 5 months
	I tried it again. This time I cleaned the bed with soap &... Dans le forum How do I print this? (Printing help)	il y a 5 months
	Yes, it is the nozzle that comes with Core One, .4mm CHT bra... Dans le forum How do I print this? (Printing help)	il y a 5 months
	Storage_box_parts Attached is the .3mf file Dans le forum How do I print this? (Printing help)	il y a 5 months

Page 3 / 5 Précédent Suivant

Statistiques du forum

613 Forums

71.9 K Sujets

505.2 K Messages

11 En-ligne

83.1 K Membres

Le dernier des messages: Hotend fan not spinning Notre nouveau membre: minimalmule Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé