Activité
 
Notifications
Clear all
Peter
Peter
Groupe: Enregistré
A(ont) rejoint: 2019/06/21
Active Member
1
Just assembled my mk4 kit. During set up it gives Heatbed ov...

Dans le forum Hardware, firmware and software help

il y a 1 year
Print size 120 mm

Dans le forum Hardware, firmware and software help

il y a 4 years
@dario-f Hi Dario, no not yet. Thank you for your suggestion...

Dans le forum How do I print this? (Printing help)

il y a 5 years
The blue marked line is correct, this is in the model. The r...

Dans le forum How do I print this? (Printing help)

il y a 5 years
I also tried it without an angle. Now I have problems at 17....

Dans le forum How do I print this? (Printing help)

il y a 5 years
Deformation in model - how to solve?

Dans le forum How do I print this? (Printing help)

il y a 5 years
Yes fully agree. The water washable would skip the IPA. It s...

Dans le forum General discussion, announcements and releases

il y a 5 years
elegoo also comes with water washable resin. Would be great ...

Dans le forum General discussion, announcements and releases

il y a 5 years
what is Dawn? a normal dish wash detergent?

Dans le forum How do I print this? (Printing help)

il y a 5 years
Due to the temperature differences it was advised by Prusa n...

Dans le forum How do I print this? (Printing help)

il y a 5 years
Wipe tower problem PVA (Primaselect)

Dans le forum How do I print this? (Printing help)

il y a 5 years
I print Prusament PETG plus PVA (Primaselect). Item is prin...

Dans le forum How do I print this? (Printing help)

il y a 5 years
I cleaned the plate with warm water and detergent. Then with...

Dans le forum How do I print this? (Printing help)

il y a 5 years
Settings Prusament PETG in combination with PVA

Dans le forum How do I print this? (Printing help)

il y a 5 years
and the temperature - first layer calibration can only be do...

Dans le forum Assembly and first prints troubleshooting

il y a 5 years
I solved it. The IR sensor gave a steady 1 with PLA. With th...

Dans le forum Assembly and first prints troubleshooting

il y a 5 years
soluble not working in the mmu2s

Dans le forum Assembly and first prints troubleshooting

il y a 5 years
Partager :