Aktivität
 
Benachrichtigungen
Alles löschen
Peter
Peter
Gruppe: Registriert
Beigetreten: 2019/06/21
Active Member
1
Just assembled my mk4 kit. During set up it gives Heatbed ov...

Im Forum Hardware, firmware and software help

Vor 1 year
Print size 120 mm

Im Forum Hardware, firmware and software help

Vor 4 years
@dario-f Hi Dario, no not yet. Thank you for your suggestion...

Im Forum How do I print this? (Printing help)

Vor 5 years
The blue marked line is correct, this is in the model. The r...

Im Forum How do I print this? (Printing help)

Vor 5 years
I also tried it without an angle. Now I have problems at 17....

Im Forum How do I print this? (Printing help)

Vor 5 years
Deformation in model - how to solve?

Im Forum How do I print this? (Printing help)

Vor 5 years
Yes fully agree. The water washable would skip the IPA. It s...

Im Forum General discussion, announcements and releases

Vor 5 years
elegoo also comes with water washable resin. Would be great ...

Im Forum General discussion, announcements and releases

Vor 5 years
what is Dawn? a normal dish wash detergent?

Im Forum How do I print this? (Printing help)

Vor 5 years
Due to the temperature differences it was advised by Prusa n...

Im Forum How do I print this? (Printing help)

Vor 5 years
Wipe tower problem PVA (Primaselect)

Im Forum How do I print this? (Printing help)

Vor 5 years
I print Prusament PETG plus PVA (Primaselect). Item is prin...

Im Forum How do I print this? (Printing help)

Vor 5 years
I cleaned the plate with warm water and detergent. Then with...

Im Forum How do I print this? (Printing help)

Vor 5 years
Settings Prusament PETG in combination with PVA

Im Forum How do I print this? (Printing help)

Vor 5 years
and the temperature - first layer calibration can only be do...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
I solved it. The IR sensor gave a steady 1 with PLA. With th...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
soluble not working in the mmu2s

Im Forum Assembly and first prints troubleshooting

Vor 5 years
Teilen: