Notifications
Clear all
perlmunger
Groupe: Enregistré
A(ont) rejoint: 2016/11/08
Active Member
1
|
Finally!
I was able to get it to print! I don't think I ca... Dans le forum Others (Archive) |
il y a 8 years | |
|
In the menu, under calibration, you have options to adjust t... Dans le forum Others (Archive) |
il y a 8 years | |
|
I have been (hopefully) having a few problems with layer dri... Dans le forum Others (Archive) |
il y a 8 years | |
|
Are you raising he print head to z=100 before preheating? I... Dans le forum Others (Archive) |
il y a 8 years | |
|
Thanks Gab. Appreciate the help. I bought the printer pre-as... Dans le forum Others (Archive) |
il y a 8 years | |
|
You may consider:
-Too much infill, try 6%, rectilinear fill... Dans le forum Others (Archive) |
il y a 8 years | |
|
Did the part detach from the bed? (I assume not by looking a... Dans le forum Others (Archive) |
il y a 8 years | |
|
Hi,
this can be caused by several things, however for now my... Dans le forum Others (Archive) |
il y a 8 years | |
|
Layer Drifting Dans le forum Others (Archive) |
il y a 8 years |