Notifications
Clear all
perlmunger
Skupina: Registrovaný
Přidal se: 2016/11/08
Active Member
1
|
Finally!
I was able to get it to print! I don't think I ca... In forum Others (Archive) |
před 8 years | |
|
In the menu, under calibration, you have options to adjust t... In forum Others (Archive) |
před 8 years | |
|
I have been (hopefully) having a few problems with layer dri... In forum Others (Archive) |
před 8 years | |
|
Are you raising he print head to z=100 before preheating? I... In forum Others (Archive) |
před 8 years | |
|
Thanks Gab. Appreciate the help. I bought the printer pre-as... In forum Others (Archive) |
před 8 years | |
|
You may consider:
-Too much infill, try 6%, rectilinear fill... In forum Others (Archive) |
před 8 years | |
|
Did the part detach from the bed? (I assume not by looking a... In forum Others (Archive) |
před 8 years | |
|
Hi,
this can be caused by several things, however for now my... In forum Others (Archive) |
před 8 years | |
|
Layer Drifting In forum Others (Archive) |
před 8 years |