Notifications
Clear all
per-form-3d
Skupina: Registrovaný
Přidal se: 2022/01/12
Active Member
1
|
The Spheres are cut on the top and bottom to get a maximum o... In forum PrusaSlicer |
před 2 months | |
|
Achieving constant number of perimeters In forum PrusaSlicer |
před 2 months | |
| Erste Schicht bei verschiedenen Materialien | před 4 years | |
|
Hey. I have the Same Problems with my MMU2S. Every unload fa... In forum Hardware, firmware and software help |
před 4 years | |
| Ich vermute das Problem an anderer Stelle: das Filament wird... | před 4 years | |
| Das täuscht. Die Welle ist gerade und der Motor läuft auch s... | před 4 years | |
| Hier sind noch mal zwei Bilder des aktuellen Drucks. Wieder ... | před 4 years | |
| Den Filamentsensor habe ich mehrmals überprüft und justiert.... | před 4 years | |
| Entladefehler MMU2S bei einfarbigen Teilen | před 4 years |