Notifications
Clear all

per-form-3d
Group: Registered
Joined: 2022/01/12
Active Member
1
The Spheres are cut on the top and bottom to get a maximum o... In forum PrusaSlicer |
6 days ago | |
Achieving constant number of perimeters In forum PrusaSlicer |
6 days ago | |
Erste Schicht bei verschiedenen Materialien | 3 years ago | |
Hey. I have the Same Problems with my MMU2S. Every unload fa... In forum Hardware, firmware and software help |
3 years ago | |
Ich vermute das Problem an anderer Stelle: das Filament wird... | 4 years ago | |
Das täuscht. Die Welle ist gerade und der Motor läuft auch s... | 4 years ago | |
Hier sind noch mal zwei Bilder des aktuellen Drucks. Wieder ... | 4 years ago | |
Den Filamentsensor habe ich mehrmals überprüft und justiert.... | 4 years ago | |
Entladefehler MMU2S bei einfarbigen Teilen | 4 years ago |