Polski
Fora
Członkowie
pcnukem
Aktywność
 
Notifications
Clear all
pcnukem
pcnukem
Grupa: Zarejestrowany
Dołączył: 2017/10/08
Active Member
1
Profil Aktywność
No I printed the Prusa slicer one 1st this is what I printed...

In forum How do I print this? (Printing help)

 2 years temu
Not the filament as I printed same part using Simplify 3d, j...

In forum How do I print this? (Printing help)

 2 years temu
Using Prusa slicer

In forum How do I print this? (Printing help)

 2 years temu
Thank you for your reply's I found a site with the kit.

In forum Hardware, firmware and software help

 2 years temu
On my MK3 I put a longer tube in the hotend so it was closer...

In forum Hardware, firmware and software help

 2 years temu
I see they use a ball bearing and two magnets but they are n...

In forum Hardware, firmware and software help

 2 years temu
MK3 to MK3s

In forum Hardware, firmware and software help

 2 years temu
Found them thank you very much Joan.

In forum Hardware, firmware and software help

 2 years temu
STL files

In forum Hardware, firmware and software help

 2 years temu
I built this as a dust cover but might make it it into a usa...

In forum Others (Archive)

 7 years temu
Share: