Prusa3D Forum

Notifications

Clear all

pcnukem

Groupe: Enregistré

A(ont) rejoint: 2017/10/08

Active Member

	No I printed the Prusa slicer one 1st this is what I printed... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Not the filament as I printed same part using Simplify 3d, j... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Using Prusa slicer Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thank you for your reply's I found a site with the kit. Dans le forum Hardware, firmware and software help	il y a 2 years
	On my MK3 I put a longer tube in the hotend so it was closer... Dans le forum Hardware, firmware and software help	il y a 2 years
	I see they use a ball bearing and two magnets but they are n... Dans le forum Hardware, firmware and software help	il y a 2 years
	MK3 to MK3s Dans le forum Hardware, firmware and software help	il y a 2 years
	Found them thank you very much Joan. Dans le forum Hardware, firmware and software help	il y a 2 years
	STL files Dans le forum Hardware, firmware and software help	il y a 2 years
	I built this as a dust cover but might make it it into a usa... Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

565 Forums

63.9 K Sujets

447.9 K Messages

16 En-ligne

69.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé