Prusa3D Forum

Notifications

Clear all

papercrane

Skupina: Registrovaný

Přidal se: 2021/08/30

Active Member

	Ah yes, I do recall replacing the PTFE tube in the hotend a ... In forum Hardware, firmware and software help	před 4 years
	MINI not extruding enough filament In forum Hardware, firmware and software help	před 4 years
	I checked and the filament sensor is definitely set to on. I... In forum Hardware, firmware and software help	před 4 years
	I print from Octoprint these days. The feedback I get from i... In forum Hardware, firmware and software help	před 4 years
	MINI+ Filament Sensor doesn't detect out-of-filament? In forum Hardware, firmware and software help	před 4 years
	Bought as a kit. When I put it together it worked fine for a... In forum Hardware, firmware and software help	před 4 years
	MINI loads filament and purges fine but does not print In forum Hardware, firmware and software help	před 4 years
	I actually figured out this problem after disassembling the ... In forum Hardware, firmware and software help	před 4 years
	X Axis binding randomly In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477 K Příspěvky

13 Online

75.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed