Activity
 
Notifications
Clear all
Page
Page
Group: Registered
Joined: 2025/05/04
Active Member
1
Ah! I think I see my initial mistake. I kept strumming the ...

In forum Hardware, firmware and software help

1 month ago
Yep at the very beginning. I also aligned the gantry accordi...

In forum Hardware, firmware and software help

1 month ago
I don't understand that either. I'm going to support what th...

In forum Hardware, firmware and software help

1 month ago
I tried it now. But this settings completely skewed my gantr...

In forum Hardware, firmware and software help

1 month ago
Here is I hope better picture. It is just perfect for me.

In forum Hardware, firmware and software help

3 months ago
So you moved the pulley closer to the motor, right? Accordin...

In forum Hardware, firmware and software help

3 months ago
Its hard to capture it right. With regular nozzle its step u...

In forum Hardware, firmware and software help

3 months ago
It may look worse on camera, but it's great to the eye. I do...

In forum Hardware, firmware and software help

3 months ago
I have just updated FW to 6.3.3. Changed nozzle to standard ...

In forum Hardware, firmware and software help

3 months ago
What do you think? Maybe this issue is really caused by belt...

In forum Hardware, firmware and software help

3 months ago
I have the new design feet and I gues VFA is not that bad as...

In forum Hardware, firmware and software help

4 months ago
Yes, they know about the VFA problem, they also told me abou...

In forum Hardware, firmware and software help

4 months ago
Same to me. There is a little gap between pulley ring and be...

In forum Hardware, firmware and software help

4 months ago
Share: