Prusa3D Forum

Notifications

Clear all

Pablo-F

Groupe: Enregistré

A(ont) rejoint: 2020/11/24

Active Member

	thank you Joan, until next time 😉 😆 Dans le forum How do I print this? (Printing help)	il y a 4 years
	yes i think so too, need to find out more about support sett... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Here you can see the finish print Dans le forum How do I print this? (Printing help)	il y a 4 years
	@joantabb i am since one week into 3D printing, and i have n... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I think with soap cleaning and 7x7 mesh bed levelling i have... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@joantabb Yes i am Zaungast the Life Adjust 'Z' My Way' but... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I do believe that a soap and water wash (with nothing else) ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@joantabb true, I'll try it can't hurt 🙂 Dans le forum How do I print this? (Printing help)	il y a 4 years
	this one i printed between and not to bad, but the next one ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@neophyl i clean with IPA like recommended Dans le forum How do I print this? (Printing help)	il y a 4 years
	@print-my-world thank you 4 your help, will try to bump up r... Dans le forum How do I print this? (Printing help)	il y a 4 years
	i am printing with PLA ultra fine or 0.20 no change.... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Help with my Prints Dans le forum How do I print this? (Printing help)	il y a 4 years

Statistiques du forum

559 Forums

63 K Sujets

443.6 K Messages

19 En-ligne

67.9 K Membres

Le dernier des messages: Nextruder Planetary Gears-Routine Lubrication and Cleaning Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé