Prusa3D Forum

Notifications

Clear all

Pablo-F

Skupina: Registrovaný

Přidal se: 2020/11/24

Active Member

	thank you Joan, until next time 😉 😆 In forum How do I print this? (Printing help)	před 4 years
	yes i think so too, need to find out more about support sett... In forum How do I print this? (Printing help)	před 4 years
	Here you can see the finish print In forum How do I print this? (Printing help)	před 4 years
	@joantabb i am since one week into 3D printing, and i have n... In forum How do I print this? (Printing help)	před 4 years
	I think with soap cleaning and 7x7 mesh bed levelling i have... In forum How do I print this? (Printing help)	před 4 years
	@joantabb Yes i am Zaungast the Life Adjust 'Z' My Way' but... In forum How do I print this? (Printing help)	před 4 years
	I do believe that a soap and water wash (with nothing else) ... In forum How do I print this? (Printing help)	před 4 years
	@joantabb true, I'll try it can't hurt 🙂 In forum How do I print this? (Printing help)	před 4 years
	this one i printed between and not to bad, but the next one ... In forum How do I print this? (Printing help)	před 4 years
	@neophyl i clean with IPA like recommended In forum How do I print this? (Printing help)	před 4 years
	@print-my-world thank you 4 your help, will try to bump up r... In forum How do I print this? (Printing help)	před 4 years
	i am printing with PLA ultra fine or 0.20 no change.... In forum How do I print this? (Printing help)	před 4 years
	Help with my Prints In forum How do I print this? (Printing help)	před 4 years

Fórum Statistiky

559 Fóra

61.9 K Témata

438.5 K Příspěvky

18 Online

66.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed