Prusa3D Forum

Notifications

Clear all

ozr2222

Group: Registered

Joined: 2019/08/09

Active Member

	ok the material is out... calibration is running... annnnnnn... In forum Hardware, firmware and software help	5 years ago
	i just noticed there is yellow filament on the y-pulley gear... In forum Hardware, firmware and software help	5 years ago
	lol ok here you go: the actual prints. Its a prusa mk2.5 wi... In forum Hardware, firmware and software help	5 years ago
	a picture tells more than a thousand words: In forum Hardware, firmware and software help	5 years ago
	thx for the advice, but is this Solution still right if the ... In forum Hardware, firmware and software help	5 years ago
	Y-Axis wont stop at its end, round shapes turn into ovals st... In forum Hardware, firmware and software help	5 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.9 K Posts

20 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed