Prusa3D Forum

Notifications

Clear all

ozr2222

Grupa: Zarejestrowany

Dołączył: 2019/08/09

Active Member

	ok the material is out... calibration is running... annnnnnn... In forum Hardware, firmware and software help	5 years temu
	i just noticed there is yellow filament on the y-pulley gear... In forum Hardware, firmware and software help	5 years temu
	lol ok here you go: the actual prints. Its a prusa mk2.5 wi... In forum Hardware, firmware and software help	5 years temu
	a picture tells more than a thousand words: In forum Hardware, firmware and software help	5 years temu
	thx for the advice, but is this Solution still right if the ... In forum Hardware, firmware and software help	5 years temu
	Y-Axis wont stop at its end, round shapes turn into ovals st... In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

20 Online

67.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte