Notifiche
Cancella tutti
Otso
Gruppo: Registrato
Registrato: 2024/01/14
Active Member
1
|
I thought about this too, that that could be a reason, but o... Nel forum PrusaSlicer |
10 months fa | |
|
What I'm asking is why are the bed leveling commands not gen... Nel forum PrusaSlicer |
10 months fa | |
|
Yes, I should I have mentioned I have the MK3S. I wrongly as... Nel forum PrusaSlicer |
10 months fa | |
|
Bed leveling in sliced G-code instead of firmware? Nel forum PrusaSlicer |
10 months fa | |
| I haven't tried it myself, but you can open the OpenSCAD fil... | 10 months fa | |
| Ok, I found the answer,/p> Some parts were designed using Op... | 10 months fa | |
| Missing STEP files in Original-Prusa-i3 github repo | 10 months fa |