Notifications
Clear all
Otso
Groupe: Enregistré
A(ont) rejoint: 2024/01/14
Active Member
1
|
I thought about this too, that that could be a reason, but o... Dans le forum PrusaSlicer |
il y a 11 months | |
|
What I'm asking is why are the bed leveling commands not gen... Dans le forum PrusaSlicer |
il y a 11 months | |
|
Yes, I should I have mentioned I have the MK3S. I wrongly as... Dans le forum PrusaSlicer |
il y a 11 months | |
|
Bed leveling in sliced G-code instead of firmware? Dans le forum PrusaSlicer |
il y a 11 months | |
|
I haven't tried it myself, but you can open the OpenSCAD fil... Dans le forum General discussion, announcements and releases |
il y a 11 months | |
|
Ok, I found the answer,/p> Some parts were designed using Op... Dans le forum General discussion, announcements and releases |
il y a 12 months | |
|
Missing STEP files in Original-Prusa-i3 github repo Dans le forum General discussion, announcements and releases |
il y a 12 months |