Prusa3D Forum

Notifiche

Cancella tutti

Omexlu

Gruppo: Registrato

Registrato: 2021/06/25

Active Member

	Yes but as I read it use M73 not M117? Don't know if it work... Nel forum PrusaSlicer	3 years fa
	[CR6-SE] PrusaSlicer - M117 Nel forum PrusaSlicer	3 years fa
	Problem with offset :/ Nel forum General software discussion	4 years fa
	I do the MBL by hand (via display) and then data is very wel... Nel forum PrusaSlicer	4 years fa
	I will try it, mesh is loaded by MBL not by ABL. These are t... Nel forum PrusaSlicer	4 years fa
	As mentioned the Cura and Prusa settings are all default, he... Nel forum PrusaSlicer	4 years fa
	Sure here the zipped files. Attachment removed Nel forum PrusaSlicer	4 years fa
	So the error is not in the start/end code but is somewhere i... Nel forum PrusaSlicer	4 years fa
	So I tried to take the Gcode from Cura, here the same, so is... Nel forum PrusaSlicer	4 years fa
	Hello, As far I know cura don't use any variables in start/e... Nel forum PrusaSlicer	4 years fa
	Maybe an option to copy start/end code from cura into pursas... Nel forum PrusaSlicer	4 years fa
	Hello, Yes I have loaded the profile that was offered in Pru... Nel forum PrusaSlicer	4 years fa
	PrusaSlicer: "Filament Runout"-Error Nel forum PrusaSlicer	4 years fa

Statistiche Forum

565 Forum

64.1 K Discussioni

449.2 K Post

17 Online

70.2 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso