Prusa3D Forum

Notifications

Clear all

Omexlu

Skupina: Registrovaný

Přidal se: 2021/06/25

Active Member

	Yes but as I read it use M73 not M117? Don't know if it work... In forum PrusaSlicer	před 3 years
	[CR6-SE] PrusaSlicer - M117 In forum PrusaSlicer	před 3 years
	Problem with offset :/ In forum General software discussion	před 4 years
	I do the MBL by hand (via display) and then data is very wel... In forum PrusaSlicer	před 4 years
	I will try it, mesh is loaded by MBL not by ABL. These are t... In forum PrusaSlicer	před 4 years
	As mentioned the Cura and Prusa settings are all default, he... In forum PrusaSlicer	před 4 years
	Sure here the zipped files. Attachment removed In forum PrusaSlicer	před 4 years
	So the error is not in the start/end code but is somewhere i... In forum PrusaSlicer	před 4 years
	So I tried to take the Gcode from Cura, here the same, so is... In forum PrusaSlicer	před 4 years
	Hello, As far I know cura don't use any variables in start/e... In forum PrusaSlicer	před 4 years
	Maybe an option to copy start/end code from cura into pursas... In forum PrusaSlicer	před 4 years
	Hello, Yes I have loaded the profile that was offered in Pru... In forum PrusaSlicer	před 4 years
	PrusaSlicer: "Filament Runout"-Error In forum PrusaSlicer	před 4 years

Fórum Statistiky

565 Fóra

64.1 K Témata

449.2 K Příspěvky

20 Online

70.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed