|
Yes but as I read it use M73 not M117? Don't know if it work... In forum PrusaSlicer |
3 years ago |
|
[CR6-SE] PrusaSlicer - M117 In forum PrusaSlicer |
3 years ago |
|
Problem with offset :/ In forum General software discussion |
4 years ago |
|
I do the MBL by hand (via display) and then data is very wel... In forum PrusaSlicer |
4 years ago |
|
I will try it, mesh is loaded by MBL not by ABL. These are t... In forum PrusaSlicer |
4 years ago |
|
As mentioned the Cura and Prusa settings are all default, he... In forum PrusaSlicer |
4 years ago |
|
Sure here the zipped files.
Attachment removed In forum PrusaSlicer |
4 years ago |
|
So the error is not in the start/end code but is somewhere i... In forum PrusaSlicer |
4 years ago |
|
So I tried to take the Gcode from Cura, here the same, so is... In forum PrusaSlicer |
4 years ago |
|
Hello, As far I know cura don't use any variables in start/e... In forum PrusaSlicer |
4 years ago |
|
Maybe an option to copy start/end code from cura into pursas... In forum PrusaSlicer |
4 years ago |
|
Hello, Yes I have loaded the profile that was offered in Pru... In forum PrusaSlicer |
4 years ago |
|
PrusaSlicer: "Filament Runout"-Error In forum PrusaSlicer |
4 years ago |
