Prusa3D Forum

Notifications

Clear all

Olep

Groupe: Enregistré

A(ont) rejoint: 2017/04/13

Active Member

	I was wondering the same. Dans le forum Hardware, firmware and software help	il y a 9 months
	Would love this. Been spending the last couple of days try... Dans le forum PrusaSlicer	il y a 2 years
	Getting new firmware for mk2s? Dans le forum General discussion, announcements and releases	il y a 3 years
	The model in this example is Batt_disp_AA_v2.stl Dans le forum Print tips (Archive)	il y a 7 years
	Reason for picture not being the same is because I cut the m... Dans le forum Print tips (Archive)	il y a 7 years
	Trouble printing with infill on narrow object. Dans le forum Print tips (Archive)	il y a 7 years
	I also use talcum powder. I start of with an clean bed, tak... Dans le forum Print tips (Archive)	il y a 7 years
	Done some more prints and its still performing well. I also ... Dans le forum Improvements (Archive)	il y a 7 years
	Improved fan shroud / nozzle Dans le forum Improvements (Archive)	il y a 7 years
	Yeah, did some experimenting, mine seems to start fine at 15... Dans le forum Others (Archive)	il y a 7 years
	Thanks, that's what I expected. Just wanted be be sure. Wie... Dans le forum Others (Archive)	il y a 7 years
	When is the fan supposed to start? Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.1 K Messages

26 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé