Prusa3D Forum

Notifications

Clear all

npl130

Grupa: Zarejestrowany

Dołączył: 2020/05/18

New Member

	@ondrowicz Yes it is PLA, I will give your guide a look. In forum Hardware, firmware and software help	5 years temu
	Understood. I did fix the screw being too tightened. So for ... In forum Hardware, firmware and software help	5 years temu
	@karl-herbert With the screw on the idler door, I've been co... In forum Hardware, firmware and software help	5 years temu
	Clicking noise then extrusion stops [Help] In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

585 Fora

68.2 K Tematy

477.9 K Posty

10 Online

75.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte