Prusa3D Forum

Notifications

Clear all

npl130

Skupina: Registrovaný

Přidal se: 2020/05/18

New Member

	@ondrowicz Yes it is PLA, I will give your guide a look. In forum Hardware, firmware and software help	před 5 years
	Understood. I did fix the screw being too tightened. So for ... In forum Hardware, firmware and software help	před 5 years
	@karl-herbert With the screw on the idler door, I've been co... In forum Hardware, firmware and software help	před 5 years
	Clicking noise then extrusion stops [Help] In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

559 Fóra

63.1 K Témata

443.9 K Příspěvky

21 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed