Prusa3D Forum

Notifications

Clear all

Noopy3D

Skupina: Registrovaný

Přidal se: 2025/05/31

Active Member

	Thanks for your answers 🙂 Here's the result I got : Surfa... In forum How do I print this? (Printing help)	před 6 months
	Well, I just got another part out with your advice, the resu... In forum How do I print this? (Printing help)	před 6 months
	Thanks for all your answers, I'm reprinting a piece with the... In forum How do I print this? (Printing help)	před 6 months
	Thank you for your answers, I will try to increase the tempe... In forum How do I print this? (Printing help)	před 6 months
	The printer is in an enclosure with the HEPA filter activate... In forum How do I print this? (Printing help)	před 6 months
	I print in 3 walls with a layer height of 0.15 mm.The height... In forum How do I print this? (Printing help)	před 6 months
	Surface defects on large prints with Prusa XL In forum How do I print this? (Printing help)	před 7 months

Fórum Statistiky

595 Fóra

69.4 K Témata

486 K Příspěvky

14 Online

79.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed