Notifications
Clear all
NH3D Canada
NH3D Canada
Groupe: Enregistré
A(ont) rejoint: 2022/01/21
Active Member
1
Heater Cartridge

Dans le forum Hardware, firmware and software help

il y a 3 years
I don't necessarily want a bigger or longer heat break i wou...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 3 years
PTFE work around

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 3 years
thanks everyone this solution worked, and im doing some more...

Dans le forum Hardware, firmware and software help

il y a 3 years
Where it messes me up the most is some of my filament have d...

Dans le forum Hardware, firmware and software help

il y a 3 years
thats an even better idea when I 1st started 3-D printing M...

Dans le forum Hardware, firmware and software help

il y a 3 years
That makes sense thanks again I will try this tonight and po...

Dans le forum Hardware, firmware and software help

il y a 3 years
That makes sense thanks again I will try this tonight and po...

Dans le forum Hardware, firmware and software help

il y a 3 years
OK so when I go into my printer's tune settings on the physi...

Dans le forum Hardware, firmware and software help

il y a 3 years
And if I can simply change this in my G code can you show me...

Dans le forum Hardware, firmware and software help

il y a 3 years
Is it in the G code or is it in the printer's firmware Every...

Dans le forum Hardware, firmware and software help

il y a 3 years
I have to agree with you when I want to just print and remov...

Dans le forum General discussion, announcements and releases

il y a 3 years
Default Flow

Dans le forum Hardware, firmware and software help

il y a 3 years
I will do that this evening thank you

Dans le forum PrusaSlicer

il y a 3 years
I'm not too sure how to do that I have never had to

Dans le forum PrusaSlicer

il y a 3 years
This is a great answer and overall I am happy with the Print...

Dans le forum PrusaSlicer

il y a 3 years
Layer lines

Dans le forum PrusaSlicer

il y a 3 years
Partager :