Notifications
Clear all
NH3D Canada
NH3D Canada
Group: Registered
Joined: 2022/01/21
Active Member
1
Heater Cartridge

In forum Hardware, firmware and software help

3 years ago
I don't necessarily want a bigger or longer heat break i wou...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
PTFE work around

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
thanks everyone this solution worked, and im doing some more...

In forum Hardware, firmware and software help

3 years ago
Where it messes me up the most is some of my filament have d...

In forum Hardware, firmware and software help

3 years ago
thats an even better idea when I 1st started 3-D printing M...

In forum Hardware, firmware and software help

3 years ago
That makes sense thanks again I will try this tonight and po...

In forum Hardware, firmware and software help

3 years ago
That makes sense thanks again I will try this tonight and po...

In forum Hardware, firmware and software help

3 years ago
OK so when I go into my printer's tune settings on the physi...

In forum Hardware, firmware and software help

3 years ago
And if I can simply change this in my G code can you show me...

In forum Hardware, firmware and software help

3 years ago
Is it in the G code or is it in the printer's firmware Every...

In forum Hardware, firmware and software help

3 years ago
I have to agree with you when I want to just print and remov...

In forum General discussion, announcements and releases

3 years ago
Default Flow

In forum Hardware, firmware and software help

3 years ago
I will do that this evening thank you

In forum PrusaSlicer

3 years ago
I'm not too sure how to do that I have never had to

In forum PrusaSlicer

3 years ago
This is a great answer and overall I am happy with the Print...

In forum PrusaSlicer

3 years ago
Layer lines

In forum PrusaSlicer

3 years ago
Share: