Prusa3D Forum

Notifications

Clear all

nazar-pc

Skupina: Support

Přidal se: 2023/11/11

Název: Member

	I think slicer could hypothetically account for default (and... In forum PrusaSlicer	před 1 year
	6.0.2 firmware (with Phase Stepping calibration) + stealth m... In forum Assembly and first prints troubleshooting	před 1 year
	I used Ecosound Macsound panels (20mm for sides and under pr... In forum Assembly and first prints troubleshooting	před 2 years
	I noticed it happens when either one of the motors is spinni... In forum Hardware, firmware and software help	před 2 years
	All bearing I have are THK SRS12GN, not sure what would be t... In forum Assembly and first prints troubleshooting	před 2 years
	Probably the same cause as instepper motors or the way they ... In forum Hardware, firmware and software help	před 2 years
	There are a few things I have noticed that are noisy: 1) LED... In forum Assembly and first prints troubleshooting	před 2 years

Fórum Statistiky

585 Fóra

68.1 K Témata

476.9 K Příspěvky

13 Online

75.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed