Prusa3D Forum

Notifications

Clear all

nazar-pc

Grupa: Support

Dołączył: 2023/11/11

Tytuł: Member

	I think slicer could hypothetically account for default (and... In forum PrusaSlicer	7 months temu
	6.0.2 firmware (with Phase Stepping calibration) + stealth m... In forum Assembly and first prints troubleshooting	7 months temu
	I used Ecosound Macsound panels (20mm for sides and under pr... In forum Assembly and first prints troubleshooting	12 months temu
	I noticed it happens when either one of the motors is spinni... In forum Hardware, firmware and software help	1 year temu
	All bearing I have are THK SRS12GN, not sure what would be t... In forum Assembly and first prints troubleshooting	1 year temu
	Probably the same cause as instepper motors or the way they ... In forum Hardware, firmware and software help	1 year temu
	There are a few things I have noticed that are noisy: 1) LED... In forum Assembly and first prints troubleshooting	1 year temu

Statystyki Forum

565 Fora

64.1 K Tematy

449 K Posty

26 Online

70.2 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte