Prusa3D Forum

Notifications

Clear all

navillus5

Group: Registered

Joined: 2019/10/04

Active Member

	PrusaSlicer output filenames for STL vs. 3MF In forum General discussion, announcements and releases	3 years ago
	MK3s - shifting and separating layers In forum How do I print this? (Printing help)	4 years ago
	So I've solved the issue. I followed this set of steps and i... In forum Hardware, firmware and software help	4 years ago
	@fuchsr Thanks again for your response, but I would really l... In forum Hardware, firmware and software help	4 years ago
	Thanks for the replies... I usually had the MINI setup to pr... In forum Hardware, firmware and software help	4 years ago
	Yes. I also adjusted the tensioning screw. When I did this I... In forum Hardware, firmware and software help	4 years ago
	Began using non-Prusament filaments and now I have all sorts... In forum Hardware, firmware and software help	4 years ago
	Hi Joan - I wanted to get back to you with thanks a some pic... In forum How do I print this? (Printing help)	4 years ago
	Hi Joan - Wow - many thanks for taking the time to actually ... In forum How do I print this? (Printing help)	4 years ago
	@joantabb Hi Joan - Thanks for the reply. This is a link to ... In forum How do I print this? (Printing help)	4 years ago
	Printing 3D plane - 1 layer walls with 0 bottom later and 0 ... In forum How do I print this? (Printing help)	4 years ago

Forum Statistics

565 Forums

64 K Topics

448.5 K Posts

19 Online

70 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed