Benachrichtigungen
Alles löschen
Nameless2nd
Nameless2nd
Gruppe: Registriert
Beigetreten: 2019/10/12
Active Member
1
You can tighten the grub screw on the x axis without disasse...

Im Forum Hardware, firmware and software help

Vor 5 years
If you dissasemble part of the Y-axis (take off the belt ten...

Im Forum Hardware, firmware and software help

Vor 5 years
Check the hotend assembly. There are problems with a gap bet...

Im Forum Hardware, firmware and software help

Vor 5 years
First tiny print: The jet from the print-in-place suprise eg...

Im Forum General discussion, announcements and releases

Vor 5 years
I'm with you, just because this is a community Forum for Pru...

Im Forum General discussion, announcements and releases

Vor 5 years
I just finished the first part of my spool holder custom fit...

Im Forum General discussion, announcements and releases

Vor 5 years
I would be less annoyed if Prusa hadn't promised nearly week...

Im Forum General discussion, announcements and releases

Vor 5 years
Well, at least you should have access. I could ony see them ...

Im Forum General discussion, announcements and releases

Vor 5 years
Last weekend I completed a bigger print (10cm x 10cm area, l...

Im Forum General discussion, announcements and releases

Vor 5 years
@steve-4 Thanks, I know these two. Printed the electronic ...

Im Forum General discussion, announcements and releases

Vor 5 years
Is there a source for the improved MINDA mount and cable mou...

Im Forum General discussion, announcements and releases

Vor 5 years
Have you disassembled, cleaned and properly reassembled the ...

Im Forum Hardware, firmware and software help

Vor 5 years
Seems I was a bit too quick, a Prusa employee stated that th...

Im Forum General discussion, announcements and releases

Vor 5 years
So, this was posted in a Facebook group: I'm trying to reac...

Im Forum General discussion, announcements and releases

Vor 5 years
You can print a Masterspool adapter and use spool-less refil...

Im Forum General discussion, announcements and releases

Vor 5 years
09. of December according to the latest blog post.

Im Forum Hardware, firmware and software help

Vor 5 years
People buying doesn't explain why they changed the informati...

Im Forum General discussion, announcements and releases

Vor 5 years
Teilen: