Notifications
Clear all
Nameless2nd
Nameless2nd
Group: Registered
Joined: 2019/10/12
Active Member
1
You can tighten the grub screw on the x axis without disasse...

In forum Hardware, firmware and software help

5 years ago
If you dissasemble part of the Y-axis (take off the belt ten...

In forum Hardware, firmware and software help

5 years ago
Check the hotend assembly. There are problems with a gap bet...

In forum Hardware, firmware and software help

5 years ago
First tiny print: The jet from the print-in-place suprise eg...

In forum General discussion, announcements and releases

5 years ago
I'm with you, just because this is a community Forum for Pru...

In forum General discussion, announcements and releases

5 years ago
I just finished the first part of my spool holder custom fit...

In forum General discussion, announcements and releases

5 years ago
I would be less annoyed if Prusa hadn't promised nearly week...

In forum General discussion, announcements and releases

5 years ago
Well, at least you should have access. I could ony see them ...

In forum General discussion, announcements and releases

5 years ago
Last weekend I completed a bigger print (10cm x 10cm area, l...

In forum General discussion, announcements and releases

5 years ago
@steve-4 Thanks, I know these two. Printed the electronic ...

In forum General discussion, announcements and releases

5 years ago
Is there a source for the improved MINDA mount and cable mou...

In forum General discussion, announcements and releases

5 years ago
Have you disassembled, cleaned and properly reassembled the ...

In forum Hardware, firmware and software help

5 years ago
Seems I was a bit too quick, a Prusa employee stated that th...

In forum General discussion, announcements and releases

5 years ago
So, this was posted in a Facebook group: I'm trying to reac...

In forum General discussion, announcements and releases

5 years ago
You can print a Masterspool adapter and use spool-less refil...

In forum General discussion, announcements and releases

5 years ago
09. of December according to the latest blog post.

In forum Hardware, firmware and software help

5 years ago
People buying doesn't explain why they changed the informati...

In forum General discussion, announcements and releases

5 years ago
Share: