Notifications
Clear all
muller.stephane
muller.stephane
Group: Registered
Joined: 2019/12/11
Active Member
1
Yes, I build the kit 10 days ago or so. Makes sense that it ...

In forum Hardware, firmware and software help

3 months ago
Thanks for your feedback! I think I managed to resolve the i...

In forum Hardware, firmware and software help

3 months ago
X-axis homing fails over and over again

In forum Hardware, firmware and software help

3 months ago
The top of the first layer is smooth. I've tried adjusting Z...

In forum Assembly and first prints troubleshooting

5 years ago
What do you mean by ridges? To me the layer looks alright. Y...

In forum Assembly and first prints troubleshooting

5 years ago
@gkmakeit Alright! We're getting somewhere I think. So I did...

In forum Assembly and first prints troubleshooting

5 years ago
@gmakeit No I didn't, I just launched a new print and though...

In forum Assembly and first prints troubleshooting

5 years ago
Thanks for all your suggestions!! @r-kolbi Will try this tod...

In forum Assembly and first prints troubleshooting

5 years ago
Any ideas? Anyone? 😟

In forum Assembly and first prints troubleshooting

5 years ago
I've tried a couple of things now since my initial post. I d...

In forum Assembly and first prints troubleshooting

5 years ago
First layers print OK but after 5mm or so it starts failing

In forum Assembly and first prints troubleshooting

5 years ago
Many thanks for taking the time to reply! I kept trying thin...

In forum Assembly and first prints troubleshooting

5 years ago
Failed prints after disassembly

In forum Assembly and first prints troubleshooting

5 years ago
Many thanks for the advice! What looks filthy on the print s...

In forum Hardware, firmware and software help

6 years ago
Print adherence

In forum Hardware, firmware and software help

6 years ago
Share: