Notifications
Clear all
muller.stephane
Skupina: Registrovaný
Přidal se: 2019/12/11
Active Member
1
| The top of the first layer is smooth. I've tried adjusting Z... | před 4 years | |
| What do you mean by ridges? To me the layer looks alright. Y... | před 4 years | |
| @gkmakeit Alright! We're getting somewhere I think. So I did... | před 4 years | |
| @gmakeit No I didn't, I just launched a new print and though... | před 4 years | |
| Thanks for all your suggestions!! @r-kolbi Will try this tod... | před 4 years | |
| Any ideas? Anyone? 😟 | před 4 years | |
| I've tried a couple of things now since my initial post. I d... | před 4 years | |
| First layers print OK but after 5mm or so it starts failing | před 4 years | |
| Many thanks for taking the time to reply! I kept trying thin... | před 4 years | |
| Failed prints after disassembly | před 4 years | |
|
Many thanks for the advice! What looks filthy on the print s... In forum Hardware, firmware and software help |
před 5 years | |
|
Print adherence In forum Hardware, firmware and software help |
před 5 years |