Notifications
Clear all
MTom
Skupina: Registrovaný
Přidal se: 2019/01/06
Trusted Member
3
| No not yet, I won´t do any more testing until I get that mis... | před 6 years | |
|
@dane-r2 : Same issue here, see picture in my other post. I ... In forum How do I print this? (Printing help) |
před 6 years | |
| No difference to direct feeding, the pullback of the filamen... | před 6 years | |
| flexible messes up when loading | před 6 years | |
| Ok I´ll try again once I got the bearing, just doesn´t make ... | před 6 years | |
| If I´d know that the loading/instant unloading is caused by ... | před 6 years | |
| loading and unloading doesn´t work too well (not really at a... | před 6 years | |
| Filament instantly gets unloaded after load | před 6 years | |
| Good question, didn´t read about the vulcano yet. | před 6 years | |
| Nova Hotend? | před 6 years | |
| As I understood the MK3 needs an upgrade as well, before it ... | před 6 years |
Stránka 3 / 3
Předchozí