Čeština
Fóra
Uživatelé
mrwsl
Aktivita
 
Notifications
Clear all
mrwsl
mrwsl
Skupina: Registrovaný
Přidal se: 2018/05/02
Active Member
1
Profile Aktivita
Last update and solution: just don't use Prusament. I bought...

In forum How do I print this? (Printing help)

 před 3 years
I wouldn't say so (also see the 2nd picture in my post above...

In forum How do I print this? (Printing help)

 před 3 years
I use a standard 0.4mm nozzle. I just replaced it just for t...

In forum How do I print this? (Printing help)

 před 3 years
My first suspect was my enclosure and heat creep. I added a ...

In forum How do I print this? (Printing help)

 před 3 years
I know it is not the model's fault. On another non Prusa pri...

In forum How do I print this? (Printing help)

 před 3 years
So weird. I'm almost through the filament spool without any ...

In forum How do I print this? (Printing help)

 před 3 years
My bad, of course. I thought I attached the 3mf file but it ...

In forum How do I print this? (Printing help)

 před 3 years
Moon Lithophane Lamp with Prusament Vanilla PLA White

In forum How do I print this? (Printing help)

 před 3 years
That didn't work for me. It seems that prusaprinter is unzip...

In forum General discussion, announcements and releases

 před 6 years
prusaprinters.org doesnt allow uploading typical 3d files

In forum General discussion, announcements and releases

 před 6 years
Can confirm this behaviour as well with the newest firmware ...

In forum Hardware, firmware and software help

 před 6 years
[...] First Layer Height - .25mm (my Live Z is set to -.85 f...

In forum Assembly and first prints troubleshooting

 před 7 years
The voice I described is not coming from the psu. The psu ha...

In forum Hardware, firmware and software help

 před 7 years
Static noise (maybe from einsy)

In forum Hardware, firmware and software help

 před 7 years
Share: