Activity
 
Notifications
Clear all
MrMik
MrMik
Group: Registered
Joined: 2016/09/21
Honorable Member
1
I have taken the extruder apart and inserted a new length of...

In forum Others (Archive)

7 years ago
This is what you get with good print adhesion and medium war...

In forum Others (Archive)

7 years ago
The photos look like what you would get (if you were using S...

In forum Print tips (Archive)

7 years ago
Actually, I've done something today that may fall into the p...

In forum Prusa i3 kit (Archive)

7 years ago
Preventative maintenance = keeping my paws of it while it's ...

In forum Prusa i3 kit (Archive)

7 years ago
If this is the right schematic I don't think these both pins...

In forum Prusa i3 kit (Archive)

7 years ago
... That made me giggle! I find it somewhat simpler to cal...

In forum Assembly and first prints troubleshooting

7 years ago
... I came across info about calibrating your extruder. Mine...

In forum Assembly and first prints troubleshooting

7 years ago
I will post up some tests, but I can confirm a few things ab...

In forum Improvements (Archive)

7 years ago
I cannot find information about the 'Rear' seam position. W...

In forum Software (Archive)

7 years ago
looking at the black bits in the pull, could they be bits of...

In forum Others (Archive)

7 years ago
In order to get another data point, have you considered usin...

In forum Others (Archive)

7 years ago
Go to Slic3r Printer Settings Tab. Have a look to the point:...

In forum Others (Archive)

7 years ago
I have not experienced personally experienced this, but I ha...

In forum Others (Archive)

7 years ago
Apologies; I have been away over the weekend. OK, looking a...

In forum Others (Archive)

7 years ago
I just had to clear a clog as well yesterday. Use one of the...

In forum Others (Archive)

7 years ago
My Prusa MK2 kit built does the same. Only on the first laye...

In forum Others (Archive)

7 years ago
The shipping is ridiculously expensive. We need to work on ...

In forum Others (Archive)

7 years ago
Maybe the PTFE tube is not properly inserted, or too short. ...

In forum Others (Archive)

7 years ago
To free up the filament melted into the heat sink, I block t...

In forum Others (Archive)

7 years ago
Page 8 / 31
Share: