MrMik – Aktywność – Prusa3D Forum

Notifications

Clear all

MrMik

Grupa: Zarejestrowany

Dołączył: 2016/09/21

Honorable Member

	Thank you , John! I took it apart and it will indeed be ver... In forum Improvements (Archive)	8 years temu
	Thanks, David. Is ColorPrint used for multi-color printing ... In forum Print tips (Archive)	8 years temu
	Difference between Colorprint and ZHop In forum Print tips (Archive)	8 years temu
	Thanks again David, explanation found! I must have shut dow... In forum Hardware, firmware and software help	8 years temu
	Thanks David! I did do a little search, but did not use fre... In forum Hardware, firmware and software help	8 years temu
	I went into Settings> Move Axis and the extruder is extru... In forum Hardware, firmware and software help	8 years temu
	Print just stopped mid-way In forum Hardware, firmware and software help	8 years temu
	Uninterruptible power supply In forum Improvements (Archive)	8 years temu
	I think that could be a very worthwhile addition to the soft... In forum Hardware, firmware and software help	8 years temu
	powered by the printers PSU where I added a barrel jack for ... In forum Improvements (Archive)	8 years temu
	Great photos of enclosures in this thread, thanks! I've bee... In forum Improvements (Archive)	8 years temu
	I added a bit of tissue paper with a hole in the middle. Sli... In forum Others (Archive)	8 years temu
	It does find the first 3 calibration points, but not the fou... In forum Others (Archive)	8 years temu
	You need to run/print v2calibration.gcode. It is on the SD ... In forum Software (Archive)	8 years temu

Strona 31 / 31 Wstecz

Statystyki Forum

559 Fora

62.9 K Tematy

443 K Posty

22 Online

67.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte