MrMik – Attività – Prusa3D Forum

Notifiche

Cancella tutti

MrMik

Gruppo: Registrato

Registrato: 2016/09/21

Honorable Member

	Thank you , John! I took it apart and it will indeed be ver... Nel forum Improvements (Archive)	8 years fa
	Thanks, David. Is ColorPrint used for multi-color printing ... Nel forum Print tips (Archive)	8 years fa
	Difference between Colorprint and ZHop Nel forum Print tips (Archive)	8 years fa
	Thanks again David, explanation found! I must have shut dow... Nel forum Hardware, firmware and software help	8 years fa
	Thanks David! I did do a little search, but did not use fre... Nel forum Hardware, firmware and software help	8 years fa
	I went into Settings> Move Axis and the extruder is extru... Nel forum Hardware, firmware and software help	8 years fa
	Print just stopped mid-way Nel forum Hardware, firmware and software help	8 years fa
	Uninterruptible power supply Nel forum Improvements (Archive)	8 years fa
	I think that could be a very worthwhile addition to the soft... Nel forum Hardware, firmware and software help	8 years fa
	powered by the printers PSU where I added a barrel jack for ... Nel forum Improvements (Archive)	8 years fa
	Great photos of enclosures in this thread, thanks! I've bee... Nel forum Improvements (Archive)	8 years fa
	I added a bit of tissue paper with a hole in the middle. Sli... Nel forum Others (Archive)	8 years fa
	It does find the first 3 calibration points, but not the fou... Nel forum Others (Archive)	8 years fa
	You need to run/print v2calibration.gcode. It is on the SD ... Nel forum Software (Archive)	8 years fa

Pagina 31 / 31 Precedente

Statistiche Forum

559 Forum

62.9 K Discussioni

443 K Post

19 Online

67.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso