Prusa3D Forum

Notifications

Clear all

mr-neutron

Groupe: Enregistré

A(ont) rejoint: 2023/06/01

Active Member

	That worked. It produced a workable print. Thank you Neophy... Dans le forum PrusaSlicer	il y a 1 year
	Thank you for the suggestions.It looks like you made the XY ... Dans le forum PrusaSlicer	il y a 1 year
	I've tried changing various settings such as layer height bu... Dans le forum PrusaSlicer	il y a 1 year
	Prusaslicer 2.8.0 putting gaps into the gcode & print?! Dans le forum PrusaSlicer	il y a 1 year
	I found the commented-out code in Prusa-Firmware-Buddy/src/g... Dans le forum Hardware, firmware and software help	il y a 2 years
	I found the commented-out code in Prusa-Firmware-Buddy/src/g... Dans le forum Hardware, firmware and software help	il y a 2 years
	THANK YOU! That worked - no blob ruining the print! Dans le forum PrusaSlicer	il y a 2 years
	I am also interested in seeing this feature added back to th... Dans le forum Hardware, firmware and software help	il y a 2 years
	I am interested in seeing this feature added back to the fir... Dans le forum Hardware, firmware and software help	il y a 2 years
	I agree. A whole wipe tower seems excessive for 1 or 2 colo... Dans le forum How do I print this? (Printing help)	il y a 2 years
	@joantabb I found a forum thread where you wrote a list of s... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I should point out that I have the same situation as the ori... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I'd also like to know how to force a wipe after a manual col... Dans le forum How do I print this? (Printing help)	il y a 2 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.8 K Messages

11 En-ligne

75.9 K Membres

Le dernier des messages: Replacing hot end. 2 wires that I can't figure where they were. Notre nouveau membre: mnentwig Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé