Prusa3D Forum

Notifications

Clear all

mpatl

Groupe: Enregistré

A(ont) rejoint: 2024/08/12

Active Member

	I guess you got a better service agent than I've gotten on t... Dans le forum General discussion, announcements and releases	il y a 7 months
	Found this solution on Reddit. User tbachtell states: I have... Dans le forum General discussion, announcements and releases	il y a 1 year
	Happened again, but this time the printer crashed on the fir... Dans le forum General discussion, announcements and releases	il y a 1 year
	What are the differences between a 3.5 and a 3.5s Dans le forum General discussion, announcements and releases	il y a 1 year
	MMU3 over current boot up alarm after resetting MK3.5 Dans le forum General discussion, announcements and releases	il y a 1 year
	I can't believe it will stay this way. Prusa has always gua... Dans le forum General discussion, announcements and releases	il y a 1 year
	Prusaslicer 2.8.0 few options for MK3.5 + MMU3 Dans le forum General discussion, announcements and releases	il y a 1 year
	I had the exact same failure with mine before I updated the ... Dans le forum Hardware, firmware and software help	il y a 1 year

Statistiques du forum

585 Forums

67.9 K Sujets

476 K Messages

10 En-ligne

75.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé