Notifications
Clear all
moggieuk
moggieuk
Group: Registered
Joined: 2017/10/29
Eminent Member
2
I'd be careful that you don't overload the PSU -- it's alrea...

In forum Hardware, firmware and software help

6 years ago
Got it now. Thanks for sharing -- really good idea.

In forum Hardware, firmware and software help

6 years ago
That sounds like a really good idea! Have you shared the pa...

In forum Hardware, firmware and software help

6 years ago
See my last post -- yes the automated method seems completel...

In forum Hardware, firmware and software help

7 years ago
stahlfabrik, thanks for your heroic efforts with this issue!...

In forum Hardware, firmware and software help

7 years ago
I just upgraded to 3.2.1 and like some of the improvements, ...

In forum Hardware, firmware and software help

7 years ago
NEW Holding currents: M911 X16 Y20 Z35 E26 Running currents:...

In forum General discussion, announcements and releases

7 years ago
I don't know if this is an RC2 problem or not but last night...

In forum General discussion, announcements and releases

7 years ago
I cut two nylon bolts to about 1/2" long and screwed them in...

In forum Hardware, firmware and software help

7 years ago
LMU8 PSFJ8-370 PSFJ8-330 PSFJ8-320

In forum General discussion, announcements and releases

7 years ago
Not sure why this should help with his Z-Axis though. :twis...

In forum Hardware, firmware and software help

7 years ago
Hi, one more thing to check is that your y-axis belt is suff...

In forum Hardware, firmware and software help

7 years ago
Yep, back left is high, but pretty nice initial bed. I'd try...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 years ago
What a great little plugin. Thank you! I had the same prob...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 years ago
Yes, addes M24 to my start Script and now the fail stats are...

In forum Hardware, firmware and software help

7 years ago
Adding ‘M24’ worked? It’s a bit of a kludge because that’s...

In forum Hardware, firmware and software help

7 years ago
Good catch. It’s probably best to create an “issue” on the ...

In forum Hardware, firmware and software help

7 years ago
I have exhausted all avenues changing the Microstepping tabl...

In forum Hardware, firmware and software help

7 years ago
I believe the "belt status" is an aggregate load measured on...

In forum Hardware, firmware and software help

7 years ago
Don't try the EXPERIMENTAL_FEATURES at all- the AVR gets tot...

In forum Hardware, firmware and software help

7 years ago
Page 1 / 2
Share: