|
For now only working with PLA and PETG so it is nice as i d... En el foro General discussion, announcements and releases |
hace 4 years |
|
Got my satin Powder Sheet this week thank you for that sugge... En el foro General discussion, announcements and releases |
hace 4 years |
|
took temp up and moved the z height even closer and it seems... En el foro General discussion, announcements and releases |
hace 4 years |
|
I will have to get one I have the textured and original stee... En el foro General discussion, announcements and releases |
hace 4 years |
|
should I be using the textured plate for petg? En el foro General discussion, announcements and releases |
hace 4 years |
|
I assume petg and pla need different z height En el foro General discussion, announcements and releases |
hace 4 years |
|
have re done my z and washed the plate with dawn today so ma... En el foro General discussion, announcements and releases |
hace 4 years |
|
downloading takes me to this when i go to open En el foro General discussion, announcements and releases |
hace 4 years |
|
was using slicer not sure what i did wrong En el foro General discussion, announcements and releases |
hace 4 years |
|
same site I exported it to obj to set my filment settings th... En el foro General discussion, announcements and releases |
hace 4 years |
|
2 runs i tried today from the above project En el foro General discussion, announcements and releases |
hace 4 years |
|
RE: fixing errors En el foro General discussion, announcements and releases |
hace 4 years |
|
i will reprint tomorrow and post a picture of that. but it s... En el foro General discussion, announcements and releases |
hace 4 years |
|
RE: fixing errors En el foro General discussion, announcements and releases |
hace 4 years |
|
fixing errors En el foro General discussion, announcements and releases |
hace 4 years |
|
Thank you En el foro PrusaSlicer |
hace 4 years |
|
Support En el foro PrusaSlicer |
hace 4 years |
