|
For now only working with PLA and PETG so it is nice as i d... In forum General discussion, announcements and releases |
před 3 years |
|
Got my satin Powder Sheet this week thank you for that sugge... In forum General discussion, announcements and releases |
před 3 years |
|
took temp up and moved the z height even closer and it seems... In forum General discussion, announcements and releases |
před 3 years |
|
I will have to get one I have the textured and original stee... In forum General discussion, announcements and releases |
před 3 years |
|
should I be using the textured plate for petg? In forum General discussion, announcements and releases |
před 3 years |
|
I assume petg and pla need different z height In forum General discussion, announcements and releases |
před 3 years |
|
have re done my z and washed the plate with dawn today so ma... In forum General discussion, announcements and releases |
před 3 years |
|
downloading takes me to this when i go to open In forum General discussion, announcements and releases |
před 3 years |
|
was using slicer not sure what i did wrong In forum General discussion, announcements and releases |
před 3 years |
|
same site I exported it to obj to set my filment settings th... In forum General discussion, announcements and releases |
před 3 years |
|
2 runs i tried today from the above project In forum General discussion, announcements and releases |
před 3 years |
|
RE: fixing errors In forum General discussion, announcements and releases |
před 3 years |
|
i will reprint tomorrow and post a picture of that. but it s... In forum General discussion, announcements and releases |
před 3 years |
|
RE: fixing errors In forum General discussion, announcements and releases |
před 3 years |
|
fixing errors In forum General discussion, announcements and releases |
před 3 years |
|
Thank you In forum PrusaSlicer |
před 3 years |
|
Support In forum PrusaSlicer |
před 3 years |
