Notifications
Clear all
mnosek
Group: Registered
Joined: 2022/06/19
Active Member
1
| For now only working with PLA and PETG so it is nice as i d... | 2 years ago | |
| Got my satin Powder Sheet this week thank you for that sugge... | 2 years ago | |
| took temp up and moved the z height even closer and it seems... | 3 years ago | |
| I will have to get one I have the textured and original stee... | 3 years ago | |
| should I be using the textured plate for petg? | 3 years ago | |
| I assume petg and pla need different z height | 3 years ago | |
| have re done my z and washed the plate with dawn today so ma... | 3 years ago | |
| downloading takes me to this when i go to open | 3 years ago | |
| was using slicer not sure what i did wrong | 3 years ago | |
| same site I exported it to obj to set my filment settings th... | 3 years ago | |
| 2 runs i tried today from the above project | 3 years ago | |
| RE: fixing errors | 3 years ago | |
| i will reprint tomorrow and post a picture of that. but it s... | 3 years ago | |
| RE: fixing errors | 3 years ago | |
| fixing errors | 3 years ago | |
|
Thank you In forum PrusaSlicer |
3 years ago | |
|
Support In forum PrusaSlicer |
3 years ago |