Activity
 
Notifications
Clear all
Mimir
Mimir
Group: Registered
Joined: 2019/11/17
Eminent Member
2
The Scandic Plate Overhang test

In forum Hardware, firmware and software help

2 months ago
Thanks, I will go to 9 or 8 perimeters and see the results....

In forum How do I print this? (Printing help)

7 months ago
Thanks. I will look into those.

In forum How do I print this? (Printing help)

7 months ago
Thanks. So if you are right, and I have no reason to believe...

In forum How do I print this? (Printing help)

7 months ago
Yes sorry, here it is.  415bb688-bol-deco-text-16-cop...

In forum How do I print this? (Printing help)

7 months ago
Thanks here is the zip file  047520b5-bol-deco-16_0.4...

In forum How do I print this? (Printing help)

7 months ago
Sure it is turned out together with auto "generated support"...

In forum How do I print this? (Printing help)

7 months ago
And the screenshot  320a2e3b-screenshot-2024-06-24-at...

In forum How do I print this? (Printing help)

7 months ago
Hope this helps  bcbe022c-pxl_20240621_160607801.jpg

In forum How do I print this? (Printing help)

7 months ago
"Autogenerated support" question

In forum How do I print this? (Printing help)

7 months ago
With all respect for your professional work and experiences ...

In forum Hardware, firmware and software help

9 months ago
I have for several years mainly used my MK3 for printing my ...

In forum How do I print this? (Printing help)

9 months ago
Good question. I would not use the G-codes prepared for my o...

In forum How do I print this? (Printing help)

9 months ago
Good to hear that you that you are able to print despite fai...

In forum Assembly and first prints troubleshooting

10 months ago
With 3.13.2 it works. Thanks again.

In forum Hardware, firmware and software help

1 year ago
Thanks, I'll try. with 3.13.2

In forum Hardware, firmware and software help

1 year ago
I have the same problem and have uploaded 3.13.1 and the p...

In forum Hardware, firmware and software help

1 year ago
I have been able to repare and replace whatever needed with ...

In forum General discussion, announcements and releases

3 years ago
Thanks Marry. Surely "Z-levelling enforced" sounds like a ve...

In forum Hardware, firmware and software help

5 years ago
Just to thank everyone who considered this question and to t...

In forum Hardware, firmware and software help

5 years ago
Page 1 / 2
Share: