Notifications
Clear all
milind.gupta
Group: Registered
Joined: 2020/09/13
Active Member
1
|
Looking for a guide to fine tune the dimensions In forum Hardware, firmware and software help |
5 years ago | |
|
Thank you Bobstro and Kevin. This is really helpful. Is ther... In forum How do I print this? (Printing help) |
5 years ago | |
|
General advice on adding supports In forum How do I print this? (Printing help) |
5 years ago | |
| I had cleaned it before as well. Did it again. Had to adjust... | 5 years ago | |
| @karl-herbert Thanks! That worked. | 5 years ago | |
| First layer separates from steel plate when printing | 5 years ago |