Notifications
Clear all
mikeev
Groupe: Enregistré
A(ont) rejoint: 2021/10/12
Active Member
1
Stupid question: are folks seeing this problem with Prusamen... Dans le forum How do I print this? (Printing help) |
il y a 2 years | |
Agreed on all points (and general sentiment)... it's frustra... Dans le forum How do I print this? (Printing help) |
il y a 2 years | |
Try disabling Arachne completely. I disabled it on mine a wh... Dans le forum How do I print this? (Printing help) |
il y a 2 years | |
I've been searching for a solution to this problem for a whi... Dans le forum How do I print this? (Printing help) |
il y a 2 years | |
The problem was Octolapse. I forgot I had enabled it, and it... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
Here's the .3mf file, if that helps:br />Also, I tried the s... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
PrusaSlicer: Vase mode keeps wiping on z-change. Really stum... Dans le forum Hardware, firmware and software help |
il y a 3 years |