Prusa3D Forum

Notifications

Clear all

Mike S

Grupa: Zarejestrowany

Dołączył: 2017/10/29

New Member

	@guy-k2 OK, I did the full reset and went through that whole... In forum Hardware, firmware and software help	5 years temu
	@david-a66 Yes, both the original and the new one both read ... In forum Hardware, firmware and software help	5 years temu
	MK3 was working great, now hot end can't get over about 180 ... In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

20 Online

67.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte